Non Marring Vertical Plate Clamps

Non-marring clamp are designed for vertical lifting and transporting of plate material. This particular range of clamps has a large jaw capacity that enables it to be used on a multitude of applications. The main feature of the non-marring plate clamps is the fact that it is non-marking, this is achieved by a special material on the jaw. These plate clamps are service-friendly, making it easy to exchange parts, which are readily available. Clamp repairs are available through the factory.

Do’s & Don'ts

• DO NOT use on smooth polished surfaces.
• DO clean the pads regularly, clean in water only.
• DO NOT use the clamp on plates with surface contamination.
• DO NOT use single clamp.
• DO inspect the clamp before each use. If pads are cut or cannot be cleaned, take clamp out of service and replace pads.